Review a linen finish sample with the wall layout before application begins. Agree the grain and sheen you want, then discuss where the applicator can start and stop work. Mark substrate joints separately so the responsible team can specify how they will be treated.
DecoPaint’s linen finish is a decorative wall treatment with a fine textile-like grain. Its published process uses crossed horizontal and vertical brush strokes to develop the woven effect. When discussing seams, be specific about whether you mean an application stop, a wall junction or a joint in the background.
Choose the grain in the room’s light
Stand the sample upright near the intended wall. Review it in daylight and under the lighting planned for the room. Look from the entrance, then from the places where people will normally sit or stand.
Compare the grain beside the nearby joinery and fabric samples. Decide how pronounced you want it to appear and discuss the reference with the applicator. A close view helps you judge the texture, while the view across the room helps you decide how much attention it draws.
Include the proposed final treatment in the sample review. Record the accepted colour and sheen with the sample reference, and keep the physical board available. If the sample changes, identify which version replaces the earlier one.
Put the wall boundaries on an elevation
Mark the full area to be finished on a drawing viewed straight on. Include door reveals and corners, with any return into a niche. Show where the finish meets skirting, joinery or another wall treatment.
Add sockets and wall lights, along with access panels. The applicator needs to see which items interrupt the surface and which details still need agreement. Confirm who completes the adjoining work and when it will be ready.
Use the drawing to discuss the extent of each application area. Ask the applicator to propose working boundaries for the selected system and site conditions. If a stop is needed on a visible wall, agree its location and how the intended result will be assessed before the work starts.
Separate application stops from substrate joints
A planned break in application and a joint in the receiving wall raise different questions. Keep both identified on the drawing, then have the responsible designer and applicator agree the relevant details. Avoid assuming the decorative texture will resolve an existing joint.
Use a short planning sheet to keep those decisions distinct:
| Item on the wall | Decision to settle |
|---|---|
| Application area | The extent the applicator proposes to complete together |
| Planned stop | Its position and the agreed review reference |
| Substrate joint | Who specifies its treatment and how the finish meets it |
| Corner or return | Where the texture continues and where it terminates |
| Joinery edge | The stopping detail and the trade completing it |
| Access panel | How the required opening remains usable |
Where the appearance of a stop or return is uncertain, discuss a representative trial with the applicator. Agree which detail it will demonstrate and who will review it. A small colour board may still need a separate junction sample.
Check readiness before the applicator starts
Have the applicator assess the receiving wall and identify the preparation required. Keep repairs and substrate work assigned to the appropriate team. Record any condition that must be resolved before the decorative work can proceed.
Review the installation sequence with the other trades. If joinery or electrical work will return after the finish, agree access and protection. Any later cut or relocation needs a discussion of the affected finish and repair approach before work proceeds.
At completion, use the accepted sample and agreed detail references for the review. Record outstanding observations by wall location, and obtain the care information for the installed system. Keep those records with the finish schedule for future maintenance.
Bring the marked wall elevation to a DecoPaint sample review, with the adjoining material samples and any known substrate joints identified. Explain which areas will remain most visible. That gives the applicator a useful basis for developing the linen texture and discussing its working boundaries.
